Magic Chef Dishwasher Parts

Magic Chef Appliance Parts

Popular Magic Chef Dishwasher Parts

Rack Track Stop
$7.70
In Stock
★★★★★
★★★★★
2 Reviews
Fix Number
FIX11746591
Manufacturer Part Number
WP8565925
This is a single rack track stop clip used to prevent the upper dish rack from sliding all the way out of the dishwasher. It is made of gray plastic and can wear with time. This is an easy repair that should not take very long to complete. Start by opening the dishwasher door, depress the tabs to remove both the front stop clips and remove the upper dish rack from the appliance. Now, using your small flat head screwdriver, release the retaining tab to remove the rear stop track that you are replacing, and pull the clip up to remove it. Install the new clip by inserting it into the support rail from the top and press it down to secure it in place.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Noisy
  • See more...

Installation Instructions

Richard from Austin, TX
Wheels on original upper rack adjust fell off and end stops would not stay on.
Removed old end stops. Pulled rack out of machine. Carefully removed old adjusters. Snapped in new adjusters. Slid rack back into the runners. Clipped in the new end stops. Done. Read more...
★★★★★
★★★★★
2 Reviews
Fix Number
FIX8260087
Manufacturer Part Number
W10518394
This is a manufacturer-approved heating element and 2 washers. If the dishes in your dishwasher are not drying or the water in the dishwasher is not getting hot, it may be due to a failed heating element. The heating element is not intended to heat the water that enters the appliance but is designed to maintain the heat of the water that enters. This part is located on the bottom of the appliance. Be sure to disconnect the power to the appliance before you begin this repair. Start this repair by disconnecting the wires from the bottom of the element in the back, remove the plastic nuts holding it in place, remove the element, and repeat these steps in reverse order to install the new part. For this beginner repair, you will need a screwdriver, wrench set, and it should be completed in less than 30 minutes.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Not draining
  • See more...

Installation Instructions

Jesse from Mandan, ND
not drying or cleaning dishes
Turned off breaker at power source. Turned off water supply valve. Disconnected water supply hose and drain hose. Removed base panel with 1/4'' nut driver. Removed power box cover screw with 1/4'' nut driver, turned off wire nuts connecting power cable and used phillips screw driver to remove ground. Removed 2 phillips screw under front of counter holding dishwasher in place. rolled dishwasher out of cabinet and layed face down on towels. Pulled two wires connected to the element marking position prior. Then removed two heater element nuts with adjustable wrench. Tipped dishwasher up, opened door and lifted out lower rack, underlower rack is heating element and lifted out. Reverse procedure to install. Read more...
Mounting Bracket
$10.03
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX11745496
Manufacturer Part Number
WP8269145
The mounting bracket is used to secure the top part of your dishwasher to the underside of your counter or cabinet. If you have solid surface counters (granite, quartz, etc.) you will likely need to side mount your appliance, and this type of bracket is sold separately. It is important to properly secure your dishwasher, as it helps to keep it level, and prevents it from moving, shaking, or tilting forwards. This is an authentic OEM part, made entirely of metal, and approximately 3 inches in length. These mounting brackets are sold individually, however most dishwashers require at least two brackets to secure the appliance to the countertop. It is recommended to check and replace all brackets at the same time, as they tend to wear at the same rate. Attaching the mounting bracket to the top of the dishwasher is simple, and just requires a pair of needle nose pliers to bend the tabs into place. When it comes time to attach your dishwasher to the countertop, please note that you will need screws (sold separately), a screwdriver, and if this is the first time the brackets are being attached, you will also need to use a drill bit to make pilot holes for the screws.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Leaking
  • See more...

Installation Instructions

julie from arroyo grande, CA
Mounting bracket broken. Upper rack wheel broken.
Upper Rack Wheel Assembly - This is a little time consuming (maybe 15 minutes), but easy. You will need to remove the entire upper rack assembly before replacing the wheels. After you remove rack assembly and the dishwasher from under the cabinet (see guidance below for brackets), you will see two hex head sheet metal screws with integral washers on the outside of the dishwasher holding the wheel assembly onto the dishwasher. Use the pliers to remove the screws and the old wheel assembly. Install the new wheel and mount assembly using the old screws since the wheel assembly doesn't come with the mounting screws. Mounting Bracket - Pretty easy. Remove port cover for both left & right mounting screws on inside of dishwasher. Remove the screws (if they haven't already fallen out). Careful - they will drop to the floor. Pull the dishwasher partially out from under the counter. Remove the old bracket(s) and install the new one(s). You will need pliers to bend the tabs over to secure them. For the Kenmore, you need to break off the longer end. Slide the dishwasher back under the counter and align the screw holes with the cabinet. I use masking tape to hold the screw on the screwdriver so it doesn't fall off when inserting into the screw hole in the cabinet. Use the flashlight to help see that the holes are aligned. Tighten the screw and you're done. Read more...
Friction Sleeve
$7.49
In Stock
★★★★★
★★★★★
3 Reviews
Fix Number
FIX11745488
Manufacturer Part Number
WP8268961
The friction sleeve, sometimes called a friction pad, is made of a flexible black plastic and measures a bit over one inch in length. It is designed to reduce the friction between the hinge and the door on your dishwasher, and helps keep it quiet when the door opens and closes. If the door to your dishwasher drops quickly when unlatched, you may need a new friction sleeve. The sleeve is sold individually however there is one located on both the left and right side of the dishwasher. We recommend replacing them at the same time so that they wear evenly. Replacing this genuine OEM part is an easy repair, but it will require you to pull the dishwasher out from under the counter.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Noisy
  • See more...

Installation Instructions

kathleen from Kenner, LA
after unlatching dishwasher door fell open-- no resistence
Pull out dishwasher, removed old sleeves (was split), released spring mechanism, slipped on new sleeves, re attached spring mechanism, reset dishwasher. Read more...
★★★★★
★★★★★
1 Review
Fix Number
FIX12578165
Manufacturer Part Number
W11175771
This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
Fixes these symptoms
  • Leaking
  • Not cleaning dishes properly
  • Will not fill with water
  • See more...

Installation Instructions

Bruce from PHENIX CITY, AL
Water leaking in from under unit
Turn the supply water off to the unit usually under the sink. If under cabinet model, usually there are 2 crews just under the counter top holding the unit in place remove these. Slide the unit out if possible for easy access to underside. Remove lower front panel (just under the door) by turning 2 plastic screws 1/4 turn. Use something stable to slightly prop up the unit such as a gallon paint can. The valve will usually be located in front left hand side. Mine was blue in color. Using a adjustable wrench remove the water supply line to the valve. Be sure to have a towel handy as there will be some water left in the line. Using pliers, compress the spring type clamp on the line that feeds from the valve to the unit and slide it back/away from the valve, then pull the hose from the valve. The valve itself will be mounted to the unit just behind a metal bracket and will have one "Phillips type"/ cross point screw in it, remove that screw and slide/wiggle the valve out. Replace it with new valve and reverse the procedures. Just don't over-tighten the inlet water line or you may damage it's sealing ability and cause a leak. Usually 1/4 turn past hand tight will do it. Turn on the water and check for leaks, a flashlight comes in handy. Then simply slide the unit back into place and replace the 2 cabinet screws. You are done! Read more...
Rack Adjuster
$11.09
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX11750255
Manufacturer Part Number
WPW10204131
This is a genuine OEM replacement rack adjuster for your dishwasher. If this part is damaged, broken, or missing it may cause issues using the top rack properly. To replace this part, first remove the top rack from your dishwasher, by removing the rack stop clips from the ends of the rails. To release the tabs, you can either use your fingers or a flat blade screwdriver to depress the locking tabs. Once the top rack has been removed and placed on a suitable work surface, the defective rack adjuster can be removed, once again using either your fingers or screwdriver to disengage the tabs. The new rack adjuster can then be snapped into place.

Installation Instructions

Anthony from EASTHAMPTON, MA
Both left and right front rack adjusters fell apart
I briefly watched a YouTube video and looked at the placement of the remaining two rack adjusters. They broken one were easy to take out. New ones were easy to put in. Just remove the top rack completely from the rails. I bought four and replaced all four just to be on the safe side Read more...
Fix Number
FIX11753379
Manufacturer Part Number
WPW10348269
If there is still water left in your dishwasher after it has finished running, there may be an issue with your drain pump. The pump is designed to remove water from the tub, and if that is not happening then it could be due to damaged that is causing the motor not to run or a crack causing a leak. If a new pump is required, this is a genuine OEM replacement part. Completing this repair will be easiest if you pull the dishwasher out from under the cabinet. You will need to disconnect both the water and electrical supply to the appliance before starting.
Fixes these symptoms
  • Leaking
  • Noisy
  • Not cleaning dishes properly
  • See more...

Installation Instructions

WILLIAM from MCKEES ROCKS, PA
Dishwasher not draining
This was one of the easiest jobs I ever did first I rremoved the excess water with a Shop-Vac then removed the kick plate two screws then removed the clamp from the drain hose pulled the electrical wiring off the pump removed the pump by turning it counterclockwise put the new pump in turning it clockwise it took less than a half-hour but a little more than 15 minutes Read more...
Chopper Assembly
$34.74
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX1734917
Manufacturer Part Number
W10083957
If your dishwasher is not cleaning your dishes properly, is not draining, or is noisy while operating, there may be an issue with your chopper assembly. The chopper is used to mince up food particles in the dishwasher, which prevents them from clogging up the pump. If you need to replace the chopper, this is a genuine OEM assembly for your dishwasher. Before beginning this repair, be sure to disconnect the power to your dishwasher. You will need to remove both the upper and lower racks from the dishwasher in order to easily access the chopper assembly. You will need a number 15 and number 20 torque screwdriver and a pair of needle nose pliers to complete this repair.
Fixes these symptoms
  • Noisy
  • Not cleaning dishes properly
  • Not draining
  • See more...

Installation Instructions

scott from ALBANY, OR
not get dishes clean anymore
Took apart cleaned out filters, put in new parts, work great now, clean dishes. Thanks for the repair video really helped. Read more...
★★★★★
★★★★★
1 Review
Fix Number
FIX5136129
Manufacturer Part Number
W10542314
This black rubber gasket is a genuine OEM replacement part for your dishwasher door. The gasket helps to provide a tight seal between the door and the tub, preventing water from leaking while the appliance is in use. Over time gaskets can become stretched out or brittle, and it should be replaced before a major leak happens. This kit also comes with a new latch strike plate for the door latch, which provides tension to ensure a tight seal.
Fixes these symptoms
  • Door latch failure
  • Door won’t close
  • Leaking
  • See more...

Installation Instructions

James from KNOXVILLE, TN
DOOR LEAKING - UPPER RACK LOOSE
EASY Read more...
Fix Number
FIX1524878
Manufacturer Part Number
154106202
This heating element mounting nut is used in dishwashers and is used to hold the nut to prevent leaking. If your nut is damaged or you notice leaking from the dishwasher, then replacing this nut will solve this problem. The tools needed for this repair are a 1/2 inch wrench, 1/4 inch nut driver, and needle nose pliers. To repair, locate the two element heating nuts. Next, disconnect connecter wire and remove nut with wrench. Tip: when installing new nut, remember to add insulator sleeve back on. As a safety precaution, remember to disconnect the water supply line before beginning this installation. Also, unplug your dishwasher from the power source.

Installation Instructions

janet from Galena, MO
water leaking out bottom
turned off power to dishwasher at the elec. panel. removed the "kickplate" off front bottom of dishwasher. leak was coming from where the heating element went thru tub. removed connector from bottom of heating element and brass nut practically fell off. it was cracked. ordered new brass nuts from this site it arrived quickly and installed it immediately. used a deep well socket to tighten the nut and leak was gone. Waaa Laaa!! Read more...

Magic Chef Dishwasher Appliance Types

Related Magic Chef Dishwasher Parts

Popular Magic Chef Dishwasher Models