OEM Craftsman Compressor Parts & Accessories

Air Compressor Kit

$67.48

Fix Number: FIX10048100
Manufacturer Part Number: K-0650

This kit is an OEM part direct from Craftsman for air compressors. This kit consists of the parts for building a piston cylinder in the compressor. It is recommended that you release air and unplug the air compressor before you install this kit. You will need a wrench set to replace this part. This kit includes two o-rings, piston ring clamp screw and the cylinder tube. This kit is made of metal and rubber components.

Fixes these symptoms

No compressed air
See more...

Ring

$11.30

Fix Number: FIX10044469
Manufacturer Part Number: DAC-308

This is a single OEM ring designed for an air compressor. The purpose of this part is to distribute the pressure and heat equally by creating a firm seal between the cylinder and piston. It has an approximate inside diameter of 48 mm and outside diameter of 62.5 mm. This small metal ring is prone to deterioration and will need to be replaced from time to time. For this replacement, you will need a screwdriver, wrench set and pliers.

Fixes these symptoms

No compressed air
See more...

Foam Fltr

$11.09

★★★★★

1 Review

Fix Number: FIX10044284
Manufacturer Part Number: D24233

Valve Plate Assembly

$54.66

★★★★★

1 Review

Fix Number: FIX10054520
Manufacturer Part Number: Z-AC-0032

Compres Ring

$8.95

Fix Number: FIX10043631
Manufacturer Part Number: CAC-248-2

Fixes these symptoms

No compressed air
See more...

Fan

$9.22

Fix Number: FIX10042312
Manufacturer Part Number: AC-0108

Installation Instructions

Steven from Darlington, SC

Air compressor was over heating and wouldn't restart after the first shut off.

Remove 1 Torx screw on end where air feeds into tank itself. Remove 2 Torx screws on other end. Pry cover apart. There are tabs that hold cover together. Remove screw that holds fan on. (my fan had dry rotted and had fallen off) Move shaft to lowest position and turn fan where hole is at the bottom. Slide onto shaft and replace bolt. Spin fan by hand to make sure it will rotate without going outside of where the cover will be when it is replaced. Put back cover on and replace the single screw. Snap front cover on and replace last 2 screws. You should be done. Plug up compressor and make sure it works correctly. Read more...

Gasket Kit

$19.03

Fix Number: FIX10044723
Manufacturer Part Number: E100959

This is an OEM gasket kit for air compressors. The gaskets contained in this kit are designed to seal the pump assembly. These gaskets form a tight fit between components, allowing it to increase pressure. This kit includes five parts in total. The kit includes an oil crankcase seal rubber gasket, square cylinder to crankcase gasket, and three round gaskets (cylinder to valve plate gasket, the centre gasket, and the valve plate to head gasket). It is normal for these parts to wear over time and need replacement. For this repair you will need a wrench set to disassemble the pump.

Fixes these symptoms

Air leak
No compressed air
See more...

Installation Instructions

Gregory from ORANGE, TX

Leaking air @ head

Change & need check value !
Running great 95.% Read more...

Oil Fl Cap

$10.72

★★★★★

2 Reviews

Fix Number: FIX10044637
Manufacturer Part Number: E100087

This is an oil fill cap with a gasket seal attached. It is sold as an individual part and is used in air compressors. It connects to the crank case cover to help contain the oil inside the unit. No tools are required, just twist to secure into place. If your air compressor is leaking oil, or this part is damaged, it will need to be replaced with this genuine OEM replacement part.