OEM Nutone Parts & Accessories

Heating Element

$75.98

Fix Number: FIX12098594
Manufacturer Part Number: S97020888

This is an OEM heating element for use with ventilation fans and ceiling heaters. Some units allow you to turn the heating function on or off. They are most commonly found in bathrooms to help heat the room. For this repair, you will start by removing the fan cover, disconnect the wire, and remove the nuts. You will then be able to pull the heating element fan housing out, remove the screws, and remove the heating element. The installation of the new part is conducted in the reverse order.

Installation Instructions

Loretta from BRIGHTON, CO

Heater element went out

Took off light cover took out heater blower and heat element. Replaced heat element and put all back together Read more...

Blower Wheel

$39.86

Fix Number: FIX10432533
Manufacturer Part Number: SNT5901A000

This is a blower wheel, which also includes the clip needed to install it. This authentic OEM blower wheel is the components that spins inside the fan housing, to produce airflow. It is made of a durable plastic and is pressed onto the shaft of the mower. The bottom (closed side) of the wheel has an outer diameter of approximately 5-3/4 inches. The top (open side) of the wheel has an approximate outside diameter of 6-3/16-inches. It is about 2-inches tall and is compatible with a 1/4-inch shaft. When viewing it from the open side, it rotates in a clockwise direction.

Lamp Diffuser

$51.06

★★★★★

1 Review

Fix Number: FIX10432313
Manufacturer Part Number: S97018564

Lens

$39.86

Fix Number: FIX10280052
Manufacturer Part Number: S89108000

Power Unit Assembly

$89.67

Fix Number: FIX10431679
Manufacturer Part Number: S0503B000

Filter

$39.86

Fix Number: FIX10280177
Manufacturer Part Number: S97007696

Grille

$56.05

Fix Number: FIX10280064
Manufacturer Part Number: S89339000

Light Lens

$39.86

★★★★★

1 Review

Fix Number: FIX10281344
Manufacturer Part Number: S99110437

This is an OEM light lens for a range hood and it is sold as an individual part. It is also sometimes referred to as a bulb cover, as this small plastic piece encases the bulb, protects and hides it. This part is easily installed by just snapping it into place, no tools required.

Installation Instructions

John C from BELLA VISTA, AR

The hood light stopped working (switch failure - not the light bulb or socket), the fan switch worked fine, but replaced anyway.

1. Shut off applicable circuit breaker to isolate power to exhaust hood.
2. Unscrewed the single machine screw holding the wiring channel cover in place. Used 1/8" nutdriver.
3. Tape labeled (R & L) the associated electrical wires to light switch and colored wires to fan switch for exact replacement.
4. Pulled off the connector wires by the metal clips using needle nose pliers (some were very stubborn (grease corrosion or tight).
5. Could not pinch the plastic expanders on switches and push through from rear as I expected. Had to pry switches from front with screwdriver, wiggle one side free, and then force switch through from back side. This was the hardest task as they fight to stay in place. They come out the front side only.
6. Inserted from the front both fan and light switches, noting the switch label positions of the new and old to get the wiring and on-off positions to be the same as the old.
7. Reconnected all the labeled wires to the new switch pole connectors.
8. Turned on circuit breaker and tested new switches.
9 . Replaced the wiring channel cover and screwed in the metal holding screw with nutdriver. Read more...