OEM Jonsered Parts & Accessories

Lawn Tractor Mandrel Assembly

$48.56

★★★★★

1 Review

Fix Number: FIX12087499
Manufacturer Part Number: 587819701

Installation Instructions

Terrence from LORENA, TX

Blade mandrel replacement

1. Remove mower deck.
2. Remove mower blade from defective mandrel.
3. Clean caked up grass from underside of mower deck.
4. Remove belt pulley from top of defective mandrel.
5. Remove four bolts fastening defective mandrel to deck. Note: bolts will most likely shear - make sure you have new ones.
6. Install new mandrel to deck using four new self-tapping bolts.
7. Reinstall mower blade to new mandrel assembly.
8. Reinstall belt pulley to new mandrel assembly.
9. Reinstall mower deck to tractor. Read more...

Ring Klip Number T5304-75

$3.99

Fix Number: FIX9143890
Manufacturer Part Number: 812000029

This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.

Wheel

$4.99

Fix Number: FIX12630280
Manufacturer Part Number: 589527301

Wheel.gage.half.spoked

Washer 25/32 x 1-1/4 x 16 Ga.

$3.99

Fix Number: FIX9008998
Manufacturer Part Number: 532121749

This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.

Blade High Lift

$17.43

Fix Number: FIX9015048
Manufacturer Part Number: 532180054

This is an OEM replacement part, sold individually. The High Lift Blade is also referred to as a 2 in 1 blade. It throws the clippings better, and is used when you are just discharging or bagging the grass clippings. If you want to Mulch your clippings you would want to purchase a Mulching Blade. This part is compatible with the mowers and tractors listed below. A wrench is needed for replacement.

Mandrel Pulley Assembly

$11.20

Fix Number: FIX9015257
Manufacturer Part Number: 532195945

This mandrel pulley is for lawn tractors. Mandrel pulley spins the blade on the mower deck of the tractor. Wear work gloves to protect your hands when installing this part.

Washer Hardened

$4.99

Fix Number: FIX9015920
Manufacturer Part Number: 532188967

Solenoid

$13.69

Fix Number: FIX16372182
Manufacturer Part Number: 582042802

Carburetor Gasket

$4.99

Fix Number: FIX9899150
Manufacturer Part Number: 16228-ZL8-000

This is a carburetor gasket and is sold individually. If your engine is running rough, it could be due to a worn or damaged gasket. The gasket is meant to provide an air tight seal, to help protect the engine. This gasket should be replaced when repairing the carburetor. When removing this part, it is advised to clean the surfaces around the carburetor gasket before installing the new one.

Washer-Spacer

$3.99

Fix Number: FIX9286886
Manufacturer Part Number: 532187690

This is an OEM lawn mower deck mandrel spacer washer, sold individually. It measures approximately 43/64-Inches in diameter, 1-1/8-Inches outer diameter, and 5/32-Inches thick (these measurements are approximate). In general, washers help to spread load, can provide insulation such as electrical, and can also help to prevent galvanic corrosion.

Jonsered Parts

Popular Jonsered Parts

Installation Instructions

Jonsered Appliance Types

Popular Jonsered Models

Jonsered Parts

Start With Your Model Number

Popular Jonsered Parts

Installation Instructions

Jonsered Appliance Types

Popular Jonsered Models