OEM Dremel Parts & Accessories

Brush & Spring

$6.29

Fix Number: FIX10259942
Manufacturer Part Number: 2610005646

These OEM replacement carbon brushes are sold as a pair and include a coiled spring attached. These brush and spring assemblies are what deliver power to a rotary tool armature. The spring transfers power and helps to secure the brush tightly in place. These brushes are in constant contact with the armature, which causes them to wear over time, and is the reason you should also inspect the armature regularly as well. If the tool is overloaded this can also cause the springs to burn. When performing this repair, be careful not to over-tighten the brush caps because they can crack.

Watch the install video

Brush & Spring (Pair)

$6.29

Fix Number: FIX10259957
Manufacturer Part Number: 2610009829

This part includes a set of two carbon brushes and two springs, sourced directly from the manufacturer. The spring bolts transmit power and hold the brush securely against the commutator. The brushes are consistently rubbing against the armature, and this will cause them to wear down over time. If the tool is overworked this can also burn the springs. For this repair, you will need to remove the old brushes, which are located behind the brush caps. There is one on each side of the tool. Installing the new brushes is simple. Line it up with the brush holder, insert it in and secure it with the cap, and the same steps are repeated on the other side.

Watch the install video

Shaft Lock Assembly

$3.99

Fix Number: FIX10259958
Manufacturer Part Number: 2610009839

This lock assembly includes one collar and one pin. It assists in locking the spindle shift. Over time, the pin can deteriorate, which results in it slipping. The retainer can also break. For this repair, start by removing the collet and collet nut, followed by the collar on the front of the tool. You will then need to disassemble the housing. You will now need to lift the motor and switch assembly out of the housing. The lock pin and retainer are located at the front of the housing and will need to be removed. The new lock can now be installed inside the tool.

Carbon Brush Set

$6.29

Fix Number: FIX17016959
Manufacturer Part Number: 2610053746

Carbon Brush Set

Flex Drive Shaft

$7.22

Fix Number: FIX12094069
Manufacturer Part Number: 2610914543

This is a drive shaft for a flex-shaft attachment. It has an approximate length of 38-3/8-inches and a diameter of 1/8-inch. This genuine OEM part is sold individually. The square ends of the drive shaft can begin to round over time, and this will prevent it from working properly. This is a very common wear part, so it is suggested to keep an extra one handy.

Collet Nut

$3.99

Fix Number: FIX10260006
Manufacturer Part Number: 2610014582

This part includes one manufacturer-approved collet nut for a multi-tool. The collet nut is what holds the bit in place. If your multi-tool will not hold a bit, this is one of the first components to inspect. It has a hexagonal shape so it can be fastened and unfastened with a wrench. To remove, press the shaft lock button and loosen the collet nut using the collet wrench.

Motor

$18.16

Fix Number: FIX10259932
Manufacturer Part Number: 2610005460

Coupling

$5.19

★★★★★

2 Reviews

Fix Number: FIX10260349
Manufacturer Part Number: 2615294309

This is an OEM coupling for multi-tools. It connects the armature and drive shaft. It also acts as a safeguard to the motor, by preventing it from burning if the drive shaft malfunctions. If your tool is left unused for a long stretch of time, this part can start to become brittle and deteriorate. This is a very popular repair part, so we suggest having a few of these in the tool box.

Watch the install video