Uni Dishwasher Parts

Start With Your Model Number

Need help finding your model number?

Find Parts Fast

Guaranteed Fit

Repair Videos

Popular Uni Dishwasher Parts

Watch the install video

Lower Spray Arm

$35.34

In Stock

Add to cart

★★★★★

★★★★★

4 Reviews

Fix Number

FIX12585623

Manufacturer Part Number

5304517203

This is a single lower spray arm found in dishwashers to spray water and detergent vigorously over the dishes. This spray arm is made of plastic, so can warp or crack with time. The holes in the spray arm can get clogged with debris, so it should be cleaned every so often. If it is beyond cleaning or damaged, it will need to be replaced. If the holes are clogged, this can sometimes mean there is a problem with the filter system, so it is a good idea to inspect this as well. For this repair, start by turning off the water supply to the dishwasher. Pull the lower rack out of the dishwasher and out of the way. Remove the lower wash arm. Using a flathead screwdriver, push the small locking tabs located on each side at the bottom of the spray arm. You should now be able to easily pull the spray arm out of the dishwasher. Align the new lower wash arm and push it down to secure it in place. Make sure it can spin freely and is not making contact with the heating element. Place the lower dishrack back into the appliance and close the door.

Fixes these symptoms

• Door latch failure
• Leaking
• Noisy
• See more...

Installation Instructions

Leesa from Clarksburg, WV

Took lower stray arm off because of draining issues, put back together and arm melted after starting.

The reviews before mine helped A LOT!! First of all, It has everything to do with making sure that when the arm is installed that it is turned until it clicks/locks in. This is why my arm melted when I put it back together the first time. I read the reviews before I purchased and that was really the only way I knew how to repair the piece. It does not come with instructions. Read more...

Watch the install video

Dishwasher Bottom Door Gasket

$21.06

In Stock

Add to cart

★★★★★

★★★★★

3 Reviews

Fix Number

FIX9495545

Manufacturer Part Number

809006501

This dishwasher door gasket is attached to the bottom of the door, creating a strong seal between the tub and the outer edge of the door. This seal is prone to wear and tear due to its constant exposure to water, detergent, and food particles. If the gasket appears cracked, broken, or you notice a leak coming from the door, it will need to be replaced immediately. This gasket measures approximately 23 inches long. For this simple repair, no tools are necessary. Open the dishwasher door and remove the bottom rack. The gasket is located right along the bottom of the door, molded inside the channel. It is held in place in the groove across the bottom. Remove the old gasket by pulling it out with your hands. Take your new silicone gasket and line it up so the notch fits into the groove and slide it in place until it is secure. Reinstall the lower dishrack. We recommend leaving the door closed for a few hours to ensure the gasket is sealed tightly.

Fixes these symptoms

• Door latch failure
• Door won’t close
• Leaking
• See more...

Installation Instructions

Everette from Hardyville, VA

Dishwasher leaking around bottom of door

Watched the video, easy replacement. Read more...

Watch the install video

Dishwasher Tub Gasket - Gray

$32.35

In Stock

Add to cart

Fix Number

FIX8260227

Manufacturer Part Number

154827601

The door gasket provides a watertight seal between the tub and the door, to keep water from leaking out of your dishwasher. If your dishwasher is leaking you may need to replace the door gasket. This gray door gasket is made of rubber and measures approximately 73 inches. For this repair, open the dishwasher door and remove the lower dish tray. Use your hands to pull out the old gasket. Clean the channel with a rag. Press the new gasket in place so it sits inside the groove in the door. Keep the door closed tightly for a few hours to ensure a strong seal is made.

Fixes these symptoms

• Door latch failure
• Door won’t close
• Leaking
• See more...

Installation Instructions

Patrick from Pleasanton, CA

leak from door

I ordered the top 3 parts in terms of probability of solving the problem (water inlet valve, tub gasket, and bottom door gasket). I installed all 3 and it did not solve the door leak. Then I realized that the bottom door gasket had come out (in other words, I had not installed it properly). I reinstalled the bottom door gasket (a critical point is that it has to be *pressed in* firmly -- there should be some resistance), and it worked. Note that the bottom door gasket is a hybrid between a true seal and a splash guard. The notch in the middle is designed to drain water from the door back into the tub. Because of that notch opening, there is sputtering and splashing at various points of the wash cycle. This appears to be by design, and those splashes result in water being absorbed by the insulating foam. Thank you to the previous submission/posting authors, as this is what clued me in. Read more...

Watch the install video

WHEEL & BUSHING ASS

$6.88

In Stock

Add to cart

Fix Number

FIX16745479

Manufacturer Part Number

5304532229

This is a single rack roller kit for your dishwasher. This kit comes with one axel/clip, and one wheel/roller. The kit is used for the lower dishrack, and allows your rack to move freely. You will need two kits for your upper and lower rack. We recommend replacing this part in pairs for an even wear. Lower rack roller and bracket assembly, grey. Wheel has been updated. If wheel pictured is not like old one, you may need to replace all wheels.

Fixes these symptoms

• Not cleaning dishes properly
• See more...

Installation Instructions

Arch from Scottville, NC

wheel on lower rack broken

I found it easy to order parts from you. The part I ordered was just a clip-on wheel for the lower rack of a dishwasher and did not need instructions. Read more...

SPRAY ARM

$41.21

In Stock

Add to cart

★★★★★

★★★★★

2 Reviews

Fix Number

FIX12705424

Manufacturer Part Number

5304518927

If the Spray Arm in the bottom of your dishwasher becomes damaged or broken, it is important to replace it as soon as possible. Broken spray arms can result in your dishes not being cleaned properly, or cause water to leak onto your floors while running. Damage commonly occurs due to the spray arm melting; it can come loose during the wash cycle, and rests against the heating element. The plastic then melts, and the arm either does not fit back into place or the holes become distorted which causes water to spray in different directions. Replacing this part is easy, and tools should not be required. First remove the lower dish rack to access the spray arm, pull out the broken piece, and pop the new one into place. Once you put the dish rack back in, you will be ready to go! Spray arms for the upper rack are sold separately.

Fixes these symptoms

• Leaking
• Noisy
• Not cleaning dishes properly
• See more...

Installation Instructions

Didi from Grand Rapids, MI

The lower sprayer arm had been knocked off and had melted against the heating coil.

I entered the model number of my dishwasher and scrolled down until I found the picture that matched the damaged part. The video that accompanied the part listing showed me how to wriggle the arm until it snapped in place. I offered the part, followed the video instructions, and everything works again! Read more...

Watch the install video

RACK ASSEMBLY UPPER GREY

$112.02

In Stock

Add to cart

Fix Number

FIX17219659

Manufacturer Part Number

5304535380

Installation Instructions

Cheryl from Riverton, UT

My two dish racks had very bad rust growing where the vinyl cover had deteriorated

I just had to roll out the bottom rack and replace it with the new one. The top rack I had to undo the plastic cap that held the rack on the track and take off the pieces that the water spray came through; three pieces. Then I had to carefully thread the wheels onto the track and put the parts back that I took off. It was very easy. The parts fit perfectly and I have washed my first batch through the dishwasher. No more rust marks on my dishes. Read more...

Watch the install video

Lower Spray Arm Support

$11.26

In Stock

Add to cart

★★★★★

★★★★★

1 Review

Fix Number

FIX12712289

Manufacturer Part Number

5304518968

This genuine OEM part is a lower spray arm support for your dishwasher. It is found in the bottom of the dishwasher and is the piece that the lower spray arm attaches to. If this part has become damaged, it should be replaced so that your dishes are properly cleaned. To complete this repair, you will need to remove the bottom rack, lower spray arm, and the glass trap in order to access the support. No tools are required to remove any of these pieces. The old support simply twists out with a clockwise turn, and the new support can be lined up with the tabs and twisted in place with a counterclockwise turn.

Fixes these symptoms

• Leaking
• Noisy
• Not cleaning dishes properly
• See more...

Installation Instructions

J D from Edgewood, WA

worn spray arm and support

remove arm pull straight up, remove strainer turn 1/4 turn, remove support three screws, install new parts Read more...

Watch the install video

RACK ASSEMBLY,LOWER,GREY

$232.22

In Stock

Add to cart

★★★★★

★★★★★

1 Review

Fix Number

FIX17219739

Manufacturer Part Number

5304535768

If the bottom rack of your dishwasher has seen better days, it may be time for a replacement. Some indicators are if it has rust spots, it will not slide in or out easily, or your dishes are not cleaning properly. This is a genuine OEM replacement dish rack and roller assembly for the lower level of your dishwasher. The dish rack is grey in color and measures approximately 21 inches wide by 22 inches deep. There are eight light-grey rollers to ensure the rack rolls in and out smoothly. No tools should be required to replace the assembly. This kit does not come with a cutlery basket, you can continue to use your old one, or a new basket can be purchased separately.

Fixes these symptoms

• Not cleaning dishes properly
• See more...

Installation Instructions

Carol from Wenonah, NJ

Lower dish rack rusted & cracked

Just rolled old one out & rolled new one in. Awesome!!! Received part within 24 hrs!!! Read more...

Watch the install video

Water Inlet Valve - 120V 60Hz

$56.98

In Stock

Add to cart

Fix Number

FIX1990907

Manufacturer Part Number

154637401

This is a genuine OEM replacement water inlet valve for your dishwasher. The water inlet valve supplies water to the dishwasher by opening and closing the solenoids attached to the valve, depending on the desired quantity of water. If your dishwasher is overfilling and leaking, or not filling with water at all, these may be signs that your valve is faulty. Other symptoms can include your dishes not cleaning properly, and the dishwasher not draining. You can check the inlet valve for continuity with a multimeter. It should show a reading between 500 - 1500 ohms if the valve is working and will read infinity if it is faulty. Another test is to open the dishwasher door while it is filling. If the tub continues to fill with water when the door is opened, the water inlet valve is defective and should be replaced.

Fixes these symptoms

• Leaking
• Noisy
• Not cleaning dishes properly
• See more...

Installation Instructions

Patrick from Pleasanton, CA

leak from door

I ordered the top 3 parts in terms of probability of solving the problem (water inlet valve, tub gasket, and bottom door gasket). I installed all 3 and it did not solve the door leak. Then I realized that the bottom door gasket had come out (in other words, I had not installed it properly). I reinstalled the bottom door gasket (a critical point is that it has to be *pressed in* firmly -- there should be some resistance), and it worked. Note that the bottom door gasket is a hybrid between a true seal and a splash guard. The notch in the middle is designed to drain water from the door back into the tub. Because of that notch opening, there is sputtering and splashing at various points of the wash cycle. This appears to be by design, and those splashes result in water being absorbed by the insulating foam. Thank you to the previous submission/posting authors, as this is what clued me in. Read more...

Watch the install video

Dishwasher Drain Hose

$26.66

In Stock

Add to cart

Fix Number

FIX9494138

Manufacturer Part Number

807117001

The drain hose connects to the pump located below the lower spray arm. It aids in proper dishwasher drainage. Size: 7.5 feet long

Fixes these symptoms

• Leaking
• Not cleaning dishes properly
• Not draining
• See more...

Installation Instructions

Mary from San Antonio, TX

Unable to drain water in washer and leak in dishwasher

Hi, I had a dishwasher and a dryer go out during the same weekend. I ordered both parts about 3 hours apart. We (my husband) and I could not have been more pleased. Both came in the same package and were here in a short amount of time. The parts and shipping totaled about $58.00. We feel that we saved about $1000 that weekend by doing the work ourselves (and not replacing them) and using a very user-friendly website to diagnose the problem and getting the right parts. We will definitely order from this company again. As a matter of fact, I did order a shelf for our refrigerator and had the same outcome- very satisfied with all. Walter and Mary Read more...

Uni Dishwasher Appliance Types

• Dishwasher Parts
• Uni Parts

Related Uni Dishwasher Parts

• Uni Dishwasher Hardware
• Uni Dishwasher Seals and Gaskets

Popular Uni Dishwasher Models

• MDB122LBS0
• MDB122LBS1
• MDB122RFS2
• MDB124BAS0
• MDB124BAS1
• MDB100RGW1
• MDB125RHS3
• MDB124BAB0
• MDB125RHB2
• MDB125RHS2
• MDB124BAB1
• MDB124BHS1
• MDB421RJB0
• DP400PD1 24" Portable
• MDB125RHD2
• MDB124BJB1
• MDB125RHB3
• MDB125RHD3